Water windows
(1) As best one can measure at the reactor there is adequate clearance
for the water windows; as indicated by dimensions below
Auditorium: | 17'-1 3/4" x 5'-3 3/4" | |
}inside dimensions, concrete to concrete | ||
Control room: | 5'-4 5/8" x 4'-4" |
(2) Talked with
done shortly. With reference to painting I would suggest the following.
that we specify that the insides of the tanks be sandblasted and
painted by P
the first or prime coat is supposed to be put on immediately
after the steel is sandblasted, which would make it difficult to
guarantee if they were prepared by
wanted.
The alternative is to do it ourselves. I don't think we could do as
well. Give me your opinion on this
RM
Yes.
CKB
I leave it to you to
go ahead.
CKB
total area to be painted, 5 windows 100 ft²
Less than 1 gallon each of the five coats are needed, but assuming that a full gallon
is bought, the cost is
Prime 780
Body 1 850
Body 2 " times
Seal 1 "
Seal 2 "
41.10
We could probably get the
excess paint for other uses.
PO 5207
(wrote on paints
windows etc)
ZnBr2 (80% H2O) density
2.5 for [gamma] rays,
Koroseal lining; some
hardening
co. recommended techniques
mineral oil (
requires only glyptal coat
Laminated glass with liquid
spacing to cut down reflection
29 N.Y. Ave.
4554 N Broadway
Offices also
Bldg